|
|
If you want to allow dial-in connections, follow these steps to test your system:
(see sacadm(1M) and pmadm(1M) commands.)
The port monitor itself may be disabled. This is shown by an 'x' in FLGS field
when pmadm -l is run.
Re-enable the port monitor by entering:
pmadm -e -p ttymonN -s term/00m
ttymonN and term/00m relate to the ttymon and serial device in use.
If incoming data is being lost on a high-speed modem, then, for maximum performance, increase the trigger level to 14 using the Serial Manager. See ``Configuring a serial port'' for more information.