flashpt(7)

flashpt -- BusLogic FlashPoint SCSI host adapter subsystem

Description

The BusLogic FlashPoint SCSI host adapter driver provides a Storage Device Interface (SDI) compliant interface to BusLogic FlashPoint SCSI Host Adapters. The supported devices include the BT-930, BT-932, BT-950, and the BT-952.

The BusLogic SCSI host adapter driver enables SDI-compliant target drivers (such as sd01 and st01) to communicate on the SCSI bus with target controllers and logical units. This allows normal access to mass-storage devices using standard system interfaces and filesystems.

It is also possible for an application to access the SCSI bus subsystem directly by using the pass-through interface. See pt_open(3X).

BusLogic SCSI adapters support the Tag Command Queueing feature as default. To disable this feature, change the value of the flashpt_do_tag variable in the /etc/conf/pack.d/flashpt/space.c file from 1 to 0. After you have changed the value in the file, rebuild the kernel for the Tag Command Queueing feature to be effective.

Files

/usr/include/sys/flashpt.h
/usr/include/sys/scsi.h
/usr/include/sys/sdi.h
/usr/include/sys/sdi_edt.h
/usr/include/sys/sdi_comm.h
/etc/conf/pack.d/flashpt/space.c

References

adsa(7), adsc(7), adse(7), adss(7), dcu(1M), dpt(7), ioctl(2), mcis(7), sc01(7), sd01(7), sdi(7), st01(7), sw01(7), wd7000(7)

Notices

Extreme caution should be exercised when using the pass-through interface. It is possible to interfere with normal system I/O and cause hangs if pass-through is used to an active device. Pass-through should only be used to a device that is otherwise quiescent.