DOC HOME SITE MAP MAN PAGES GNU INFO SEARCH PRINT BOOK
 

snmp(1Msnmp)


snmp -- SNMP start/stop script

Synopsis

/etc/init.d/snmp start

/etc/init.d/snmp stop

Description

The snmp command is used to start or stop the Simple Network Management Protocol (SNMP) software.

This command should be run in either of the following two ways:

sh /etc/init.d/snmp start
sh /etc/init.d/snmp stop

SNMP will start automatically at system startup time if /etc/init.d/snmp is linked to /etc/rc2.d/Snsnmp. By default, n is installed as 73.

SNMP will stop automatically at system shutdown time if /etc/init.d/snmp is linked to /etc/rc1.d/Knsnmp. By default, n is installed as 67.

See rc1(1M) and rc2(1M) for further information.


NOTE: A transport service for SNMP must be initialized before SNMP is started.

References

getid(1Msnmp), getmany(1Msnmp), getnext(1Msnmp), getone(1Msnmp), getroute(1Msnmp), rc1(1M), rc2(1M), setany(1Msnmp), sh(1), snmpd(1Msnmp), snmpstat(1Msnmp), trap_rece(1Msnmp), trap_send(1Msnmp)
© 2004 The SCO Group, Inc. All rights reserved.
UnixWare 7 Release 7.1.4 - 25 April 2004