Bringing the system back after emergency media is created

1. Undo the steps in step 4 of the previous procedure to restore the ODM configuration. When you use mknod(1M) to create the /.io/bootdisk/*root nodes, use the major and minor numbers listed by the following command:
   
   ls -l /dev/vx/dsk/rootvol

2. Rebuild the kernel again:
   
   /etc/conf/bin/idbuild -B

3. Reboot using the init 6 command. When you see the UnixWare logo appear, immediately press <Space> to enter the Bootstrap Command Processor. Enter the command initstate=1, followed by ``'boot'''. This will cause the machine to boot into single-user mode.

4. When the system comes back up, log in as root, and run vxconfigd(1M) to start the ODM configuration daemon

5. Re-attach the plexes disconnected earlier, for the mirrored disk.

   For example:
   
   vxplex att home home-02
   vxplex att home2 home2-02
   vxplex att rootvol rootvol-02
   vxplex att standvol standvol-02
   vxplex att swapvol swapvol-02
   vxplex att tmp tmp-02
   vxplex att var var-02

   You should also remove the comments from other ODM-defined slices you previously commented out.

6. Reboot using init 6 and let the machine boot all the way into multiuser mode.