ISDN_CONNECT_B3.ISDN_IND(D7isdn)
ISDN_CONNECT_B3.ISDN_IND --
ISDN incoming logical connection indication
Synopsis
#include <sys/stream.h>
#include <sys/mdi.h>
#include <sys/types.h>
#include <sys/scoisdn.h>
typedef struct isdn_connect_b3_ind
{
isdnNCCI_t ncci;
isdnNCPI_t ncpi;
} isdn_connect_b3_ind_t;
Description
The ISDN_CONNECT_B3.ISDN_IND message consists of one
M_PROTO(D7str)
message block indicating an incoming call for a logical connection.
A Network Control Connection Identifier is assigned, which
subsequently identifies the incoming call. Additional
protocol-dependent information will be transferred with the
ncpi
parameter, if available.
The connection is the set-up phase at this point. The
successful set-up will be indicated by an
ISDN_CONNECT_B3_ACTIVE.ISDN_IND(D7isdn)
message.
Parameters
ncci
-
Network Control Connection Identifier; see
isdnNCCI(D4isdn).
ncpi
-
Network Control Protocol Identifier; see
isdnNCPI(D4isdn).
The value of this parameter depends on the protocol used.
References
Intro(D4isdn),
Intro(D7isdn)
ISDN_CONNECT_B3.ISDN_REQ(D7isdn),
ISDN_CONNECT_B3.ISDN_CONF(D7isdn),
ISDN_CONNECT_B3.ISDN_RESP(D7isdn)
``SCO ISDN adapter drivers'' in Developing MDI network adapter drivers
19 June 2005
© 2005 The SCO Group, Inc. All rights reserved.
OpenServer 6 and UnixWare (SVR5) HDK - June 2005