mount_ufs(1M)

mount_ufs -- mount ufs filesystems

Synopsis

mount [-F ufs] [generic_options] [-r] [-o specific_options]
[special|mount_point]
mount [-F ufs] [generic_options] [-r] [-o specific_options]
special mount_point

Description

generic_options are options supported by the generic mount command. mount attaches a ufs filesystem, referenced by special, to the filesystem hierarchy at the pathname location mount_point, which must already exist. If mount_point has any contents prior to the mount operation, these remain hidden until the filesystem is once again unmounted.

ufs-specific options

-F ufs

Specify the ufs FSType. If -F ufs is not specified heuristics similiar to those used by fstyp(1M) are used to determine the file system type.

NOTE: This command executes faster if it is not required to autodetect file system types. If possible, specify the -F ufs.

-r

Mount the filesystem read-only.

-o

Specify the ufs filesystem specific options in a comma-separated list. If invalid options are specified, a warning message is printed and the invalid options are ignored. Multiple filesystem-specific options may be listed in any order, but must be separated by commas. The following options are available:

f: Fake an /etc/mnttab entry, but do not actually mount any filesystems. Parameters are not verified.
n: Mount the filesystem without making an entry in /etc/mnttab.
rw | ro: Read/write or read-only. Default is rw.
nosuid: By default the filesystem is mounted with setuid execution allowed. Specifying nosuid overrides the default and causes the filesystem to be mounted with setuid execution disallowed.
remount: Used in conjunction with rw. A filesystem mounted read-only can be remounted read-write. Fails if the filesystem is not currently mounted or if the filesystem is mounted rw.
soft: Specifies that writes need not be written out to disk until the filesystem is about to be unmounted. This volatility can improve system throughput as much as eight percent when the temporary directories (for example, /tmp and /var/tmp) are mounted this way.

Files

/etc/mnttab: mount table

References

fstyp(1M), mkdir(2), mnttab(4), generic mount(1M), mount_memfs(1M), mount(2), open(2), umount(2)

Notices

If the directory on which a filesystem is to be mounted is a symbolic link, the filesystem is mounted on the directory to which the symbolic link refers, rather than on top of the symbolic link itself.